Skip to main content

Removing the power paddle card

Use this information to remove the power paddle card.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To remove the power paddle card, complete the following steps.

  1. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
    Attention
    Do not allow the server to fall over.
  2. Unlock and remove the left-side cover (see Removing the left-side cover).
  3. Remove the air baffle (see Removing the air baffle).
  4. Remove all long cards from the system board.
  5. Remove the fan cage assembly (see Removing the fan cage assembly),
  6. Disconnect all connected cables from the power paddle card cage assembly.
  7. Remove the power supplies (see Removing a hot-swap power supply).
  8. Rotate the power supply air baffle up.
    Figure 1. Rotate the air baffle up
    Rotate the air baffle up
  9. Grasp on the handle of paddle card cage assembly and pull it out of the server.
    Figure 2. Power paddle card removal
    Power paddle card removal
  10. Loosen the screw to release the power paddle card top cover.
    Figure 3. Loosen screw to release cover
    Loosen screw to release cover
  11. Loosen the five screws to release the power paddle card.
    Figure 4. Release the power paddle card cover
    Release the power paddle card cover

If you are instructed to return the server component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.