Skip to main content

Removing a RAID adapter battery or flash power module

Use this information to remove a remotely installed RAID adapter battery or flash power module.

If a RAID adapter battery or flash power module is installed near the fan cage and you need to replace it, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect all power cords.
  3. Remove the cover (see Removing the cover).
  4. Remove any cable covering or obstructing the holder before opening the holder.
  5. Pull the release tab toward the fan cage and unlock the retention clip.
    Figure 1. RAID adapter battery or flash power module removal
    RAID adapter battery or flash power module removal
    Attention
    Make sure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.
  6. Disconnect the cable from the connector on the battery.
    Note
    You don't have to disconnect the cable from the flash power module.
  7. Lift the battery or flash power module up to remove the it from the holder.

If you are instructed to return the RAID adapter battery or flash power module, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.