Removing the system board

Use this information to remove the system board.

1. Read the safety information that begins on Safety, Handling static-sensitive devices, and Installation guidelines.
2. Turn off the server and any attached devices.
3. Turn off the peripheral devices and disconnect all power cords.
   Note

   When you replace the system board, you must either update the server with the latest firmware or restore the pre-existing firmware that the customer provides on a diskette or CD image. Make sure that you have the latest firmware or a copy of the pre-existing firmware before you proceed.
4. Pull the power supplies out of the rear of the server, just enough to disengage them from the server.
5. Remove the cover (see Removing the cover).
6. Remove the air baffle (see Removing the air baffle).
7. Remove all PCI riser-card assemblies and adapters (see Removing a PCI riser-card assembly and Removing an adapter).
8. Remove the ServeRAID SAS/SATA controller (see Removing a ServeRAID SAS/SATA controller).
9. Remove the dual-port network adapter (see Removing the dual-port network adapter).
10. Remove the memory modules and set them aside on a static-protective surface for reinstallation (see Removing a memory module).
    Note

    Make a note of the location of each DIMM as you remove it, so that you can later reinstall it in the same connector.
11. (Trained technician only) Remove all heat sinks and microprocessors, and set them aside on a static-protective surface for reinstallation (see Removing a microprocessor and heat sink).
    Note

    1. Remove the socket covers from the microprocessor sockets on the new system board and place them on the microprocessor sockets of the system board you are removing.
    2. Do not allow the thermal grease to come in contact with anything, and keep each heat sink paired with its microprocessor for reinstallation. Contact with any surface can compromise the thermal grease and the microprocessor socket. A mismatch between the microprocessor and its original heat sink can require the installation of a new heat sink.
12. Remove the system battery (see Removing the system battery).
13. Disconnect all cables from the system board. Make a list of each cable as you disconnect it; you can then use this as a checklist when you install the new system board (see Internal cable routing and connectors for more information).
    Attention

    Disengage all latches, release tabs or locks on cable connectors when you disconnect all cables from the system board. Failing to release them before removing the cables will damage the cable sockets on the system board. The cable sockets on the system board are fragile. Any damage to the cable sockets may require replacing the system board.
14. Remove the hot-swap fans (see Removing a hot-swap fan).
15. Rotate the fan assembly bracket up toward the front of the server.
    Figure 1. Fan assembly bracket rotation
    
    
16. Loosen the two thumbscrews (one is near PCI slot 2 and one is between fans 4 and 5).
    Figure 2. Thumbscrews disengagement
    
    
17. Grasp the system board handles and slide the system board toward the front of the server until it stops.
    Figure 3. System-board standoffs
    
    

    Note

    Make sure that the system board disengage from all system-board standoffs.
18. Grasp the system board handles and lift up the system board and carefully remove it from the server, being careful not to damage any surrounding components.
    Figure 4. System board removal
    
    
19. Remove the socket covers from the microprocessor sockets on the new system board and place them on the microprocessor sockets of the old system board that you are removing.
20. If you are instructed to return the system board, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
    Attention

    Make sure to place the socket covers for the microprocessor sockets on the system board before returning the system board.