Skip to main content

Replacing a RAID adapter battery holder

Use this information to replace a RAID adapter battery holder.

To install a RAID adapter battery holder, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect all power cords and external devices; then, remove the cover (see Removing the cover).
  3. Install the optional ServeRAID adapter battery (see Replacing a RAID adapter battery/flash power module remotely in the server).
  4. Grasp the handle and slide the holder most of the way into the bay.
    Figure 1. RAID adapter battery holder installation
    RAID adapter battery holder installation
  5. Connect the battery power cables to the ServeRAID connector.
  6. Make sure that the battery holder is secured firmly on the air baffle.
  7. Install the filler.
  8. Replacing the cover (see Replacing the cover).
  9. Slide the server into the rack.
  10. Reconnect the power cords and all external cables, and turn on the server and peripheral devices.