Skip to main content

Removing the 240 VA safety cover

Use this information to remove the 240 VA safety cover.

To remove the 240 VA safety cover, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server, and disconnect all power cords and external cables.
  3. Remove the cover (see Removing the cover).
  4. Remove the screw from the safety cover.
    Figure 1. 240 VA safety cover removal
    240 VA safety cover removal
  5. Disconnect the hard disk drive backplane power cables from the connector in front of the safety cover.
  6. Slide the cover forward to disengage it from the system board, and then lift it out of the server.
  7. If you are instructed to return the 240 VA safety cover, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.