Skip to main content

Server controls, LEDs, and power

This section describes the controls and light-emitting diodes (LEDs) and how to turn the server on and off.

For the locations of other LEDs on the system board, see System-board LEDs.

  • Front view
    The following illustration shows the controls, LEDs, and connectors on the front of the server.
  • Rear view
    The following illustration shows the connectors and LEDs on the rear of the server.
  • System-board internal connectors
    The following illustration shows the internal connectors on the system board.
  • System-board external connectors
    The following illustration shows the external connectors on the system board.
  • System-board switches and jumpers
    The following illustration shows the location and description of the switches, jumpers, and buttons.
  • System-board LEDs
    The following illustration shows the light-emitting diodes (LEDs) on the system board.
  • Server power features
    When the server is connected to an ac power source but is not turned on, the operating system does not run, and all core logic except for the TMM is shutdown.
1 Racks are measured in vertical increments of 4.45 cm (1.75 inches) each. Each increment is called a "U." A 1-U-high device is 1.75 inches tall