Skip to main content

Remove a heat sink Torx T30 nut

This task has instructions for removing a PEEK (Polyether ether ketone) Torx T30 nut on the heat sink.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding systems.

  • Do not touch the processor contacts. Contaminants on the processor contacts, such as oil from your skin, can cause connection failures.

Note
The heat sink, processor, and processor carrier for your system might be different from those shown in the illustrations.

Procedure

  1. Make preparations for this task.
    1. Remove the top cover. See Remove the rear top cover.
    2. Remove the air baffle. See Remove the air baffle.
    3. Remove the PHM. See Remove a processor and heat sink.
  2. Remove the Torx T30 nut.
    Figure 1. Removing a Torx T30 nut from the heat sink
    Removing a Torx T30 nut from the heat sink

    Note
    Do not touch the gold contacts on the bottom of the processor.
    1. Rotate the anti-tilt wire bail inwards.
    2. Push the upper edge of the Torx T30 nut towards the center of the heat sink until it disengages.
    3. Remove the Torx T30 nut.
      Attention
      Visually inspect the removed Torx T30 nut, if the nut is cracked or damaged, make sure no debris or broken pieces are left inside your server.

After you finish

  1. Install a new Torx T30 nut. See Install a heat sink Torx T30 nut.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube