Skip to main content

SMTP/SNMP/PEF

Configured SMTP and SNMP traps allow users to monitor the enclosure for selected events. SMTP/SNMP trap event types can be set on the PEF (Platform Event Filters) page.

Figure 1. SMTP
SMTP
  • SMTP: You can enable, configure and test SMTP email alert on this page.

    • Click Send Alert # to test email alerts.

    • Check Global Alerting Enable on the PEF page to enable email alerts.

    • The following information provides the default values:

      • All email alerts disabled

      • Email server address = 0.0.0.0

      • Authentication disabled

    Note
    1. Before sending an email alert, make sure that the changes to Sender Information, Destination Email Address, SMTP (email) Server Setting, and SMTP Authentication have been saved by clicking Apply.

    2. When the SMM2 SEL is full, no new event entry can be added to the SEL. SMTP event emails will not be generated until the log is cleared.

Figure 2. SNMP
SNMP
  • SNMP: You can enable, configure and test SNMP traps on this page.

    • Click Send Test Trap to test event traps.

    • Community Name displays and configures the SNMP community name using only alphabet and numerical values. The value must not be empty.

    • All the events would be sent to the destination IP address when Global Alerting Enable is checked on the PEF page.

    • For SNMP trap type, check the Generate PEF box for targeted types of events.

      Note
      1. Before sending a test trap, make sure that the changes to the target Destination and Community String have been saved by clicking Apply.

      2. When the SMM2 SEL is full, some PEF alerts might be missing or be sent repeatedly.

    • The following information provides the default values:

      • All traps disabled

      • Community Name = public

Figure 3. PEF — DA240 Enclosure
PEF — DA240 Enclosure
Figure 4. PEF — DW612 and DW612S Enclosure
PEF — DW612 and DW612S Enclosure
  • PEF: You can set SMTP/SNMP trap event types on this page.

    • The following information provides the default values:

      DA240 Enclosure
      • Global Alerting Enable unchecked

      • None of the filters selected

      DW612 and DW612S Enclosure
      • Global Alerting Enable checked

      • Generic Type, Discrete Chassis (GPUWaterLoop Chk) Informational Filter checked