Skip to main content

Install the cross braces

Use this information to install the cross braces.

About this task

Attention

Procedure

Install the front and the rear cross braces (14x Phillips #1 screws).
Figure 1. Cross brace installation (SD650 V3)
Cross brace installation (SD650 V3)
After you finish
  1. Install the tray cover. See Install the tray cover.

  2. Install the tray into the enclosure. See Install a DWC tray in the enclosure.

  3. Connect all required external cables to the solution.
    Note
    Use extra force to connect QSFP cables to the solution.
  4. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.

Demo video

Watch the procedure on YouTube