Install the tray cover
Use this information to install the tray cover.
About this task
Attention
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Note
The following illustration might differ slightly from your hardware, but the installation method is the same.
Procedure
Position the cover on top of the tray and slide the cover towards the front of the tray.
Figure 1. Tray cover installation
Important
Before you slide the cover forward, make sure that all the tabs on the front, rear, and side of the cover are engaged with the enclosure correctly. If all the tabs do not engage the enclosure correctly, it will be very difficult to install the cover later.
After you finish
Install the tray into the enclosure. See Install a DWC tray in the enclosure.
- Connect all required external cables to the solution.NoteUse extra force to connect QSFP cables to the solution.
Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.
Demo video
Give documentation feedback