Skip to main content

Install a power adapter (Desktop mount)

Follow instructions in this section to install power adapter(s).

About this task

  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
  • S035
    shock hazard
    CAUTION

    Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

CAUTION

Power adapters to the node must be of the same brand, power rating, wattage or efficiency level.

As required by COMMISSION REGULATION (EU) 2019/424 of 1 March 2020 laying down ecodesign requirements for servers and data storage products (ErP lot 9).
ThinkEdge 140W 230V/115V External Power Supply

Information published

Value and precision

Unit

Manufacturer’s name

Lenovo

-

Model identifier

Adapter

-

Input voltage

100-240

V

Input AC frequency

50-60

Hz

Output voltage

28.0

V

Output current

5.0

A

Output power

140.0

W

Average active efficiency

  • FSP: 91.0 / 91.0
  • Delta: 92.1 / 91.6

%

Efficiency at low load (10 %)

  • FSP: 88.5 / 87.5
  • Delta: 77.4 / 77.4

%

No-load power consumption

  • FSP: 0.065 / 0.08
  • Delta: 0.078 / 0.047

W

Procedure

Note
ThinkEdge SE100 node only supports 140W power adapter. If only one power adapter is to be installed, it is recommended to connect the power adapter to power connector 1.

Connect the power cable to the node.
  1. Align the screw holes and install the power cable to the node.
  2. Tighten the screw and make sure the power cable is securely locked.
    Figure 1. Installing the power cable

After you finish

  1. Complete the parts replacement. See Complete the parts replacement.