Install the Bluetooth antenna

Follow instructions in this section to install the Bluetooth antenna.

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

• Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

Note

This task requires a wrench. If necessary, use the wrench that comes in the PMB air baffle. Loosen the screw that secures the wrench to disengage the wrench from the air baffle.

Figure 1. Disengaging the wrench

1. Insert the Bluetooth antenna into the slot.
   Figure 2. Installing the Bluetooth antenna
   
   
2. Place a washer between the chassis and the screw nut if necessary; then, fasten the screw nut with the wrench to secure the Bluetooth antenna.
   Figure 3. Installing the Bluetooth antenna
   
   

   Note

   The optional kit of antenna comes with a washer. However, the washer is an optional part that enhances friction, and is not required in general scenarios. Consider applying it when necessary.
3. Connect the Bluetooth antenna cable to the wireless adapter.
   1. Pinch and press the side of the cable holder on the XCC WLAN and Bluetooth module; then, lift up one end of the cable holder from the wireless adapter.
      Figure 4. Lifting the cable holder
      
      
   2. Pivot the cable holder to 2 unlock position.
      Figure 5. Pivoting the cable holder
      
      
   3. If applicable, remove the protection cover from the cable.
   4. Gently press the cable connector down until it clicks in the connector on the WLAN module.
      Figure 6. Connecting the cable
      
      
   5. Pivot the cable holder to 1 lock position.
      Figure 7. Pivoting the cable holder
      
      
   6. Press the side of the cable holder; then, insert the cable holder to the slot on the wireless adapter. Make sure the cables are secured by the cable holder.
      Figure 8. Inserting the cable holder
      
      
4. Install the wireless adapter.
   1. Align the wireless adapter with the standoffs on the system board; then, lower the wireless adapter until it is firmly seated.
   2. Secure the wireless adapter with three screws.
   Figure 9. Installing the wireless adapter