Install the simple-swap drive backplate
Use this information to install the drive backplate.
To install the simple-swap drive backplate, complete the following steps:
Two 3.5-inch drive backplate
Four 3.5-inch drive backplate (connects to onboard connectors)
Four 3.5-inch drive backplate (connects to RAID adapter)
- Insert the backplate into the chassis with an angle as shown. Make sure the pins are against the backplate on the backside.
- Rotate the backplate up toward the front of the server.
- Close the retaining clips to secure the backplate.
- Connect the backplate cables to the system board and the RAID adapter (if installed). See Backplate cables.
Install the top cover onto the server (see Install the top cover).
Install the server into the rack if necessary.
Reconnect power cords and all external cables.