Top view
This section contains information on the top view of the server with standard heat sinks or a direct water cooling module (DWCM).
Note
The following illustrations show the top view of the server without any air baffle, middle cage, or rear cage installed.
The following illustrations show the server rear configuration with three riser assemblies. The server rear configurations vary by server model. For details, see Rear view.
Top view with standard heat sinks
Figure 1. Top view with standard heat sinks
| 1 Front backplane(s) | 2 Intrusion switch |
| 3 System fans | 4 Memory modules |
| 5 Processor and heat sink modules (PHM) | 6 Riser assemblies |
| 7 System board assembly | 8 CFF RAID adapter/expander |
Note
The illustration shows the server with CFF adapters which are available only in the 2.5-inch chassis. In some configurations, there might be installed with a RAID flash power module. For details, see Table 1.
Top view with DWCM
Figure 2. Top view with DWCM
| 1 Outlet hose | 2 Inlet hose |
| 3 Hose holder | 4 Liquid detection sensor module |
| 5 Cold plate assembly | 6 Riser cage for DWCM |
Give documentation feedback