Skip to main content

Remove the 7mm drive backplanes

Use this information to remove the 7mm drive backplanes.

About this task

Attention

  • Read Installation Guidelines to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

Note
Depending on the specific type, your backplane might look different from the illustration in this topic.

  1. Prepare your server.
    1. Remove the top cover. See Remove the top cover.
    2. Remove all the installed drives and fillers (if any) from the drive bays. See Remove a hot-swap drive.
    3. Record the cable connections for 7mm drives and then disconnect all cables from the backplanes. For information about the backplane cable routing, see 7mm drives.
    4. Remove the 7mm drive assembly from the rear chassis. See Remove the 7mm drive cage(1–slot) or Remove the 7mm drive cage(3–slot).
  2. Remove the 7mm drive backplane on the top.
    Figure 1. 7mm drive backplane removal (top)
    7mm drive backplane removal (top)

    1. Remove the two screws as shown.
    2. Vertically lift the backplane up and put it aside.
  3. Remove the 7mm drive backplane at the bottom.
    Figure 2. 7mm drive backplane removal (bottom)
    7mm drive backplane removal (bottom)

    1. Remove the screw as shown.
    2. Remove the backplane horizontally from the cage as shown.

After you finish

If you are instructed to return the old backplanes, follow all packaging instructions and use any packaging materials that are provided.

Demo video

Watch the procedure on YouTube