Skip to main content

Remove the front 2.5-inch-drive backplane

Use this information to remove the front 2.5-inch-drive backplane.

About this task

Attention

  • Read Installation Guidelines to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

Note
Depending on the specific type, your backplane might look different from the illustration in this topic.

  1. Prepare your server.
    1. Remove the top cover. See Remove the top cover.
    2. Remove the system fan cage for easier operation. See Remove a system fan.
    3. Remove all the installed drives and fillers (if any) from the drive bays. See Remove a hot-swap drive.
  2. Remove the 2.5-inch-drive backplane.
    Figure 1. 2.5-inch-drive backplane removal
    2.5-inch-drive backplane removal

    1. Lift the release tabs.
    2. Rotate the backplane backward slightly to release it from the two pins on the chassis.
  3. Record the cable connections on the backplane and then disconnect all cables from the backplane. See 2.5-inch/3.5-inch drive backplane (power) and 2.5-inch/3.5-inch drive backplane (signal).

After you finish

If you are instructed to return the old backplane, follow all packaging instructions and use any packaging materials that are provided.

Demo video

Watch the procedure on YouTube