Skip to main content

Install the TPM card (for Chinese Mainland only)

Use this information to install the TPM card.

Before installing the TPM card, touch the static-protective package that contains the new TPM card to any unpainted surface on the outside of the server. Then, take the new TPM card out of the package and place it on a static-protective surface.

The TPM card is located on the system board under the drive cage. To install the TPM card, complete the following steps:

Insert the TPM card into the TPM connector on the system board.
Note

  • Carefully handle the TPM card by its edges.

  • Your TPM card might look slightly different from the illustration.

Figure 1. Installing the TPM card
TPM card installation
After installing the TPM card:

  1. Install the drive cage. See Install the drive cage.

  2. Install the top cover. See Install the top cover.

  3. Push up on the latches on the slide rails and push the server back into the rack.

  4. Tighten the two captive screws located on the front of the server to secure the server in the rack.

    Note
    Always secure the system in the rack if your are moving the rack.

  5. Connect all cables to the ports on the front of the server, including the management port, if necessary, and all PCIe adapter ports. The management port and PCIe adapter ports are located in the I/O expansion cage.

  6. Connect power cords to both power supplies, which are located at the rear of the server.