Skip to main content

Install the 2.5-inch drive backplane module

Follow instructions in this section to install the 2.5-inch drive backplane module.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.
Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Procedure

  1. If necessary, install the backplane bracket to the 2.5-inch drive backplane.
    1. Align the backplane bracket with the backplane, and place it onto the backplane.
    2. Fasten the two screws to secure the backplane bracket to the backplane.
    Figure 1. 2.5-inch drive backplane bracket installation
    2.5-inch drive backplane bracket installation
  2. Align the 2.5-inch drive backplane module with the guide holes on the drive cage; then, lower the backplane module into the drive cage until it clicks into place.
    Figure 2. 2.5-inch drive backplane module installation
    2.5-inch drive backplane module installation

After you finish

  1. Reconnect the power and signal cables to the 2.5-inch drive backplane. See 2.5-inch drive backplane cable routing for more information.
  2. Reinstall the 2.5-inch hot-swap drives or drive bay fillers (if any) into the drive bays. See Install a 2.5-inch hot-swap drive.
  3. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube