Skip to main content

Front operator panel LEDs

This section contains information about the front operator panel LEDs.

Figure 1. Front operator panel LEDs
Front operator panel LEDs
Table 1. Front operator panel LEDs
1 Power button and power LED (green)3 System ID button/LED (blue)
2 Network Activity LED (green)4 System Error LED (yellow)

1 Power button and power LED (green)

Press this button to turn the server on and off manually. The states of the power LED are as follows:

StatusColorDescription
OffNonePower is not present, or the power supply has failed.
Fast blinking (about four flashes per second)Green
  • The server is off, but the XClarity Controller is initializing, and the server is not ready to be powered on.

  • System-board-assembly power has failed.

Slow blinking (about one flash per second)GreenThe server is off and is ready to be powered on (standby state).
Solid onGreenThe server is on and running.

2 Network Activity LED (green)

The network activity LED helps you identify the network connectivity and activity.

StatusColorDescription
OnGreenThe server is connected to a network.
BlinkingGreenThe network is connected and active.
OffNoneThe server is disconnected from the network.

3 System ID button/LED (blue)

Use this system ID button and the blue system ID LED to visually locate the server. Each time you press the system ID button, the state of the system ID LED changes. The LED can be changed to on, blinking, or off. You can also use the Lenovo XClarity Controller or a remote management program to change the state of the system ID LED to assist in visually locating the server among other servers.

4 System Error LED (yellow)

The system error LED helps you to determine if there are any system errors.

StatusColorDescriptionAction
OnYellow
An error has been detected on the server. Causes might include one or more of the following errors:
  • The temperature of the server reached the non-critical temperature threshold.

  • The voltage of the server reached the non-critical voltage threshold.

  • A fan has been detected to be running at low speed.

  • The power supply has a critical error.

  • The power supply is not connected to the power.

Check the Event log to determine the exact cause of the error.

OffNoneThe server is off or the server is on and is working correctly.None.