Skip to main content

Front I/O module

This section contains information on the front I/O module

The following illustrations show the front I/O module. To locate the front I/O module, see Front view.
Figure 1. Front I/O module
Front I/O module
Table 1. Components on the front I/O module
1 Mini DisplayPort connector2 USB 3.1 Gen 1 (5 Gbps) connector with USB 2.0 Lenovo XClarity Controller Management
3 USB 3.1 Gen 1 (5 Gbps) connector 

1 Mini DisplayPort connector

Connect a monitor to this connector.

Note
The maximum video resolution is 1920 x 1200 at 60 Hz.

2 USB 3.1 Gen 1 (5 Gbps) connector with USB 2.0 Lenovo XClarity Controller Management

Connect a USB 2.0 device, such as a mouse, keyboard, or other devices, to this connector.
Note
This is the only USB port that supports USB automation update of the firmware and RoT security module.

Connection to Lenovo XClarity Controller is primarily intended for users with a mobile device running the Lenovo XClarity Controller mobile application. When a mobile device is connected to this USB port, an Ethernet over USB connection is established between the mobile application running on the device and the Lenovo XClarity Controller.

Select Network in BMC Configuration to view or modify settings.

Four types of settings are available:

  • Host only mode

    In this mode, the USB port is always solely connected to the server.

  • BMC only mode

    In this mode, the USB port is always solely connected to Lenovo XClarity Controller.

  • Shared mode: owned by BMC

    In this mode, connection to the USB port is shared by the server and Lenovo XClarity Controller, while the port is switched to Lenovo XClarity Controller.

  • Shared mode: owned by host

    In this mode, connection to the USB port is shared by the server and Lenovo XClarity Controller, while the port is switched to the server.

3 USB 3.1 Gen 1 (5 Gbps) connector

The USB 3.1 Gen 1 (5 Gbps) connector can be used to attach a USB-compatible device, such as a USB keyboard, USB mouse, or USB storage device.