Install a cable guide
Follow instructions in this section to install a cable guide. The procedure must be executed by a trained technician.
About this task
Attention
- Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
- Two people and one lifting device on site that can support up to 400 lb (181 kg) are required to perform this procedure. If you do not already have a lifting device available, Lenovo offers the Genie Lift GL-8 material lift that can be purchased at Data Center Solution Configurator. Make sure to include the Foot-release brake and the Load Platform when ordering the Genie Lift GL-8 material lift.
See corresponding instructions below for proper installation procedure.
Left or right cable guide
Note
Make sure you have a torque screwdriver available to properly replace the component.
Procedure
Lower the cable guide into the system shuttle and route the cables through it.
Tighten the four screws marked with J to secure the cable guide.NoteTighten the screws with a torque screwdriver set to the proper torque. For reference, the torque required for the screws to be fully tighten is 0.9 ± 0.2 newton-meters.Figure 1. Left cable guide installation
Figure 2. Right cable guide installation
After you finish
- Push the system shuttle fully into the chassis.
- Lift the two lock latches on both sides of the shuttle.
- Slide the shuttle into the chassis.
Push the shuttle fully into the chassis.
Rotate the two release levers until they lock into place.
Figure 3. System shuttle installation
- Complete the parts replacement. See Complete the parts replacement.
Middle cable guide
Procedure
- Fasten the two screws to secure the cable guide.Figure 4. Middle cable guide installation
After you finish
- Reinstall the system shuttle. See Install the system shuttle.
- Complete the parts replacement. See Complete the parts replacement.
Give documentation feedback