Install the OCP module

Follow instructions in this section to install the OCP module.

About this task

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

The system may support a 2-port or a 4-port OCP module for network connections. Port numbering are shown in the illustrations below.

Figure 1. Port numbering — 2-port OCP module

Figure 2. Port numbering — 4-port OCP module

Firmware and driver download: You might need to update the firmware or driver after replacing a component.

• Go to Drivers and Software download website for ThinkSystem SR680a V4 to see the latest firmware and driver updates for your server.

• Go to Update the firmware for more information on firmware updating tools.

Procedure

1. If the OCP is covered with a OCP filler, remove the filler from the system shuttle.
2. Install the OCP module.
   1. Slide the OCP module into the slot until it is fully seated.
   2. Tighten the thumbscrew to secure the OCP module. Use a screwdriver if necessary.
   Figure 3. OCP module installation