Skip to main content

Install the retimer board shuttle release levers

Follow instructions in this section to install the retimer board shuttle release levers.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Install the retimer board shuttle release levers.
    1. Fasten the screw to secure the release lever to the shuttle.
    2. Repeat to install the other release lever.
    Figure 1. Retimer board release lever installation
    Retimer board release lever installation
  2. Engage the retimer board shuttle with the GPU shuttle.
    1. Press the two blue release latches.
    2. Rotate the two release levers until they are perpendicular to the shuttle.
    3. Slide the retimer board shuttle fully into the system shuttle
    4. Rotate the two release levers until they lock into place.
    Figure 2. Retimer board shuttle engagement
    Retimer board shuttle engagement

After you finish

  1. Complete the parts replacement. See Complete the parts replacement.