Skip to main content

Install the rail kit to the rack

See this section to learn how to install the rails to the rack.

(Optional) If the system is being installed into a shallow rack or with a 0U PDU in the rear, the CMA brackets may need to be removed to reduce the length of the rails (see Appendix: Remove the CMA bracket).
  1. Install the rear mounting pins to the rack.

    Square hole rack
    Round hole rack
    • ① Align the mounting pins and the hook latch with the rack flanges.
    • ② Push the rail in until the latch clicks into place.
  2. Install the front mounting pins to the rack.

    • ① Rotate and hold the latch.
    • ② Align the pins with the mounting flanges, and pull the rail forward.
    • ③ Release the latch to secure the rail to the rack.
  3. Repeat the previous two steps on the other rail.
  4. Proceed to System installation.