Skip to main content

Remove the server cover

Follow instructions in this section to remove the server cover.

About this task

To avoid potential danger, read and follow the following safety statements.
  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
  • S014
    shock hazard
    CAUTION
    Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.
  • S033
    240VA shock hazard
    CAUTION

    Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

Attention

  • Read the Installation guidelines to ensure that you work safely.

  • Turn off the server and peripheral devices, and disconnect the power cords and all external cables (see Power off the server).

  • If the server is in a rack, remove it from the rack.

  • Remove any locking device that secures the server cover, such as a Kensington lock or a pad lock.

Procedure

Remove the server cover.
  1. Loosen the thumbscrew that secures the server cover with a screwdriver.
    Note
    The thumbscrew is an integrated part of the server cover. Do not try to remove it from the server cover.
  2. Slide the server cover towards the rear of the server until the server cover is disengaged from the chassis.
  3. Pivot the server cover outwards and remove it from the chassis. Place the cover on a flat clean surface.
Figure 1. Removing the server cover
Removing the server cover
Attention
For proper cooling, always install the server cover before powering on the server. Operating the server without the cover properly installed might result in server component damage.

After this task is completed

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube