Install the M.2 drive
Use this information to install the M.2 drive.
Before installing the M.2 drive:
Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.
Obtain a #1 Phillips screwdriver and a 4.5mm hex socket screwdriver
To install the M.2 drive, complete the following steps:
Two different M.2 drive lengths are supported by the server - 42mm and 80mm drives. If necessary, by using a 4.5mm hex socket screwdriver, remove the standoff and screw it to the appropriate mounting point to accommodate the specific drive.
|1 Standoff for 42 mm M.2 drive||2 Standoff for 80 mm M.2 drive|
- Insert the M.2 drive at an angle into the connector; then, rotate it.
- Using a #1 Phillips screwdriver, tighten the screw that you saved earlier to secure the drive to the system board.Figure 2. M.2 drive installation