Install the flash power module

Follow this procedure to install the flash power module.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

To install the flash power module, complete the following steps:

1. Press the release tab, and align the bottom of the flash power module to the slot on the retainer; then, firmly press the flash power module until it snaps in place.
   Figure 1. Installing the flash power module into the retainer
   
   
2. Align the flash power module assembly with the corresponding holes on the chassis, and slide it forward until it snaps in place.
   Figure 2. Installing the flash power module assembly
   
   
3. Connect the cable to the flash power module adapter and the RAID adapter.
   Figure 3. Connecting the flash power module cable