Skip to main content

Remove the server cover

Follow this procedure to remove the server cover.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
S014
shock hazard
CAUTION
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.
S033
240VA shock hazard
CAUTION

Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

Complete the following steps to remove the server cover:

  1. Remove the two screws that secure the cover to the chassis.
    Figure 1. Removing the server cover
    Removing the server cover
  2. Press and hold on the release button, and slide the cover towards the rear of the server to remove it.
    Attention
    For proper cooling, always install the server cover before powering on the server. Operating the server without the cover properly installed might result in server component damage.