Replacing parts

This section provides installation and removal procedures for all serviceable system components. Each component replacement procedure references any tasks that need to be performed to gain access to the component being replaced.

Note

Ensure that you have updated the firmware and have applied the required settings after the component replacement. See Firmware/drivers/software updates.

• SD530-based servers: SD530-based servers

• SE350-based servers: SE350-based servers

  Note

  To identifying a drive slot number in HX1021, follow the steps below:

  1. From the Prism GUI, select Hardware > Diagram from the drop down list to locate the Serial Number.
  2. Login to the Lenovo XClarity Controller page using the BMC IP. Under Inventory > Storage Device, the drive slot number will be located on the left of the Serial Number under the Bay column.

• SR630-based servers: SR630-based servers

• SR630 V2-based servers: SR630 V2-based servers

• SR630 V3-based servers: SR630 V3-based servers

• SR645-based servers: SR645-based servers

• SR645 V3-based servers: SR645 V3-based servers

• SR650-based servers: SR650-based servers

• SR650 V2-based servers: SR650 V2-based servers

• SR650 V3-based servers: SR650 V3-based servers

• SR665 V3-based servers: SR665 V3-based servers

• SR950-based servers: SR950-based servers