Installing a hot-swap hard disk drive
Use this information to install a hot-swap hard disk drive.
To install a 2.5-inch hot-swap SAS or SATA hard disk drive, complete the following steps.
Note
If you have only one hard disk drive, you must install it in the upper-left bay.
- Read the safety information that begins on Safety and Installation guidelines.
- Remove the filler panel from the empty drive bay.
- Touch the static-protective package that contains the drive to any unpainted metal surface on the server; then, remove the drive from the package and place it on a static-protective surface.
- Install the hard disk drive in the drive bay:
- If you are installing additional hot-swap hard disk drives, do so now.
If you have other devices to install or remove, do so now. Otherwise, go to Completing the installation.
Give documentation feedback