Skip to main content

W.3808002 : [W.3808002] An error occurred while saving UEFI settings to the IMM.

[W.3808002] An error occurred while saving UEFI settings to the IMM.

Error Updating System Configuration to IMM

Severity​

Warning

User Response​

Complete the following steps:

  1. Use the Setup Utility to verify and save the settings (which will recover the settings).
  2. Power cycle the system.
  3. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
  4. Verify that the IMM firmware level is compatible with the UEFI firmware level. If not, update the IMM firmware.
  5. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
  6. Replace the system board.