Removing and replacing FRUs

This section provides information for removing and replacing FRUs in the server.

FRUs must be installed only by trained service technicians.

The illustrations in this document might differ slightly from your hardware.

• Removing the fan board
  Use this information to remove the fan board from the server.
• Installing the fan board
  Use this information to install the fan board.
• Removing the hard disk drive cage assembly
  Use this information to remove the hard disk drive cage assembly from the server.
• Replacing the hard disk drive cage assembly
  Use this information to replace the hard disk drive cage assembly.
• Removing a microprocessor and heat sink
  Use this information to remove a microprocessor and heat sink.
• Replacing microprocessor and heat sink
  The following notes describe the type of microprocessor that the server supports and other information that you must consider when you install a microprocessor and heat sink.
• Removing the power interface board
  Use this information to remove the power interface board from the server.
• Installing the power interface board
  Use this information to replace the power interface board.
• Removing the power interface board bracket
  Use this information to remove the power interface board bracket from the server.
• Installing the power interface board bracket
  Use this information to replace the power interface board bracket.
• Removing the system management board and backplane assembly
  Use this information to remove the system management board and backplane assembly from the server.
• Installing the system management board and backplane assembly
  Use this information to replace the system management board and backplane assembly.