Single data and management network (Nutanix AHV)

In this topology, both the data network and management network are the same network. All communications between Lenovo XClarity Administrator and the network occurs over the Eth0 network interface on the host. The XClarity Administrator Eth1 network interface is not enabled.

Before you begin

Ensure that all appropriate ports are enabled, including ports that XClarity Administrator requires (see Port availability).

Ensure that the minimum required firmware is installed on each device that you intend to manage using XClarity Administrator. You can find minimum required firmware levels from the XClarity Administrator Support – Compatibility webpage by clicking the Compatibility tab and then clicking the link for the appropriate device types..

Important

Configure the servers in ways that minimize IP address changes. Consider using static IP addresses instead of Dynamic Host Configuration Protocol (DHCP). If DHCP is used, ensure that IP address changes are minimized.

About this task

Important

Implementing a shared data and management network can cause disruptions in traffic, such as packets being dropped or management-network connectivity issues, depending on your network configuration (for example, if traffic from servers have a high priority and traffic from the management controllers have a low priority). The management network uses UDP traffic in addition TCP. UDP traffic can have a lower priority when the network traffic is high.

The following figure illustrates one way to set up your environment if the data network and management network are the same network. The numbers in the figure correspond to the numbered steps in the following sections.

Note

This figure does not depict all cabling options that might be required for your environment,. Instead, this figure shows only the cabling-option requirements as they relate to setting up a single data/management network.

Figure 1. Sample single data and management network topology (Nutanix AHV)
Illustrates a single data and management network in a KVM-based environment.

Illustrates a single data and management network in a KVM-based environment.

Important

You can setup XClarity Administrator on any system that meets the requirements for XClarity Administrator, including a managed server. If you use a managed server for the XClarity Administrator host:

You must implement either a virtually separate data and management network topology or a single data and management network topology.
You cannot use XClarity Administrator to apply firmware updates to that managed server. Even when only some of the firmware is applied with immediate activation, XClarity Administrator forces the target server to restart, which would restart XClarity Administrator as well. When applied with deferred activation, only some firmware is applied when the XClarity Administrator host is restarted.

If you intend to install XClarity Administrator to manage an existing rack server that has already been configured, proceed to Step 3. Install and configure the Lenovo XClarity Administrator virtual appliance.

For additional information about planning for this topology, including information about network settings and Eth1 and Eth0 configuration, see Single data and management network.

Give documentation feedback