Skip to main content

Installing the hard disk drive backplate

Use this information to install the hard disk drive backplate.

Before you install the hard disk drive backplate, complete the following steps:
  1. Read Safety and Installation guidelines.
  2. If the compute node is installed in an Lenovo NeXtScale n1200 Enclosure, remove it (see Removing a compute node from a chassis for instructions).
  3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.

To install the hard disk drive backplate, complete the following steps.

Figure 1. Installing backplate for 2.5-inch
Graphic illustrating installing backplate
Figure 2. Installing backplate for 1.8-inch
Graphic illustrating installing backplate

  1. Remove the cover (see Removing the compute node cover).
  2. Align the backplate with the hard disk drive cage and the connector on the system board and press the backplate into position until it is fully seated in the connector.
  3. Close the release latch.
  4. Slide the hard disk drive into the bay until it is firmly seated in the connector.
  5. Lock the hard disk drive into place by closing the release lever.
After you install the hard disk drive backplate, complete the following steps:
  1. Install the cover onto the compute node (see Installing the compute node cover for instructions).
  2. Install the compute node into the chassis (see Installing a compute node in a chassis for instructions).