Skip to main content

Install the cross braces

Use this information to install the cross braces.

About this task

Attention
Watch the procedure
  • A video of this procedure is available at YouTube.

Procedure

  1. Install the front and the rear cross braces (x14 Phillips #1 screws, x7 screws for each cross brace).
    Figure 1. Front and rear cross braces installation
    Front and rear cross braces installation
  2. Installing the front cable cover (x4 M3.5 screws).
    Figure 2. Front cable cover installation
    Front cable cover installation
After you finish

  1. Install the tray cover. See Install the tray cover.

  2. Install the tray into the enclosure. See Install a DWC tray in the enclosure.

  3. Connect all required external cables to the solution.
    Note
    Use extra force to connect QSFP cables to the solution.

  4. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.