Skip to main content

Remove the tray cover

Use this information to remove the tray cover.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Turn off the corresponding DWC tray that you are going to perform the task on.

  • Disconnect all external cables from the enclosure.

  • Use extra force to disconnect QSFP cables if they are connected to the solution.

Watch the procedure
  • A video of this procedure is available at YouTube.

Procedure

  1. Remove the tray from the enclosure. See Remove a DWC tray from the enclosure.
  2. Press on the release latch and the push point at the same time and slide the cover toward the rear of the DWC tray.
    Figure 1. Tray cover removal
    Tray cover removal
  3. Lift the cover off the DWC tray and set it aside.
    Note
    Service label instructions are located on the underside of each tray cover.
After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.