Remove the bottom intrusion switch with cable

Follow instructions in this section to remove the bottom intrusion switch with cable.

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See Configuration guide.

Procedure

1. Make preparation for this task.
   1. Remove the bottom cover. See Remove the bottom cover.
2. Disconnect the intrusion switch cable from the I/O module board.
   Figure 1. Bottom intrusion switch cable routing
   
   

   1 Intrusion switch connector on the I/O module board

3. Remove the intrusion switch.
   1. Loosen the screw that secures the intrusion switch.
   2. Pinch and slide the intrusion switch to remove it.
   Figure 2. Removing intrusion switch with cable
   
   
4. Separate the bracket from the intrusion switch cable.
   Figure 3. Separating the intrusion switch from the bracket