Four 3.5-inch hot-swap drive cable routing
Use this section to understand how to route cables for four 3.5-inch hot-swap drive model.
Note
Connections between connectors; 1↔1, 2↔2, 3↔3, ... n↔n
When routing the cables, ensure that all cables are routed appropriately through the cable guides and cable clips.
Four SATA/SAS drives (Software RAID)
Figure 1. Four SATA/SAS drives (Software RAID)
| From | To | Cable |
|---|---|---|
| 1 Backplane: Power | System board: Backplane power | Power 2x8 pin to power 2x6 pin (550 mm) |
| 2 Backplane: SATA signal | System board: SATA 0-3 | Mini-SAS HD x4 to Mini-SAS HD x4 (310 mm) |
Four SATA/SAS drives (Hardware RAID/HBA)
Figure 2. Four SATA/SAS drives (Hardware RAID/HBA)
| From | To | Cable |
|---|---|---|
| 1 Backplane: Power | System board: Backplane power | Power 2x8 pin to power 2x6 pin (550 mm) |
| 2 Backplane: SATA signal |
|
|
Give documentation feedback