Skip to main content

Install the top cover

Use this information to install the top cover.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
S014
shock hazard
CAUTION
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.
S033
240VA shock hazard
CAUTION

Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • If the server is installed in a rack, remove the server from the rack.

  • Make sure that all cables, adapters, and other components are installed and seated correctly and that you have not left loose tools or parts inside the server.

  • Make sure that all internal cables are correctly routed. See Internal cable routing.

Procedure

  1. Align the posts inside the top cover with the slots on the chassis.
  2. Hold the front of the server and slide the top cover towards the front of the server until it clicks into place.
    Figure 1. Top cover installation
    Top cover installation

After you finish

Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube