Remove the intrusion switch
Follow instructions in this section to remove the intrusion switch.
About this task
To avoid potential danger, read and follow the following safety statements.
S002
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
If the server is installed in a rack, remove the server from the rack.
Procedure
- Locate intrusion switch location in the chassis.
Table 1. Intrusion switch location Figure 1. Intrusion switch location in 2.5-inch drive model
Figure 2. Intrusion switch location in 3.5-inch drive model
1 Intrusion switch location - Pinch the two tabs on the intrusion switch towards each other, and pull the intrusion switch out.Figure 3. Removing the intrusion switch
After you finish
Install a replacement unit. See Install the intrusion switch.
If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Demo video
Give documentation feedback