Skip to main content

Install a rearwall bracket

Use this information to install a rearwall bracket.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Touch the static-protective package that contains the new part to any unpainted surface on the outside of the server. Then, take the new part out of the package and place it on a static-protective surface.
  2. Install the rearwall brackets.
    1. Align the rearwall bracket with the chassis, and insert the bracket into place.
    2. Install the screws to secure the rearwall bracket.
    Note
    The illustrations show installing the A1, B1, and C1 rearwall brackets. The procedure is the same for installing other rearwall brackets.
    Figure 1. A1 rearwall bracket installation (left)
    A1 rearwall bracket installation
    Figure 2. B1 rearwall bracket installation (middle)
    B1 rearwall bracket installation
    Figure 3. C1 rearwall bracket installation (right)
    C1 rearwall bracket installation

After you finish

  1. Install a rear drive cage or riser assemblies.

  2. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube