Parts list

Use the parts list to identify each of the components that are available for your server.

For more information about ordering the parts shown in Figure 1:

Parts list

Note

Depending on the model, your server might look slightly different from the illustration.

Figure 1. Server components

Graphic showing all parts associated with the server

The parts listed in the following table are identified as one of the following:

Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.
Tier 2 customer replaceable unit (CRU): You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.
Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.
Consumable and Structural parts: Purchase and replacement of consumable and structural parts is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

Table 1. Parts list
Index	Description	Tier 1 CRU	FRU	Consumable and Structural parts
For more information about ordering the parts shown in Figure 1: Parts list It is highly recommended that you check the power summary data for your server using Lenovo Capacity Planner before purchasing any new parts.
`1`	Top cover	√
`2`	RAID adapter	√
`3`	LOM-adapter air baffle			√
`4`	LOM adapter	√
`5`	Memory module (DCPMM might look slightly different from the illustration)	√
`6`	Heat sink		√
`7`	Processor		√
`8`	TCM/TPM adapter (for Chinese Mainland only)		√
`9`	System board		√
`10`	P4 GPU air baffle	√
`11`	FHHL V100 GPU air baffle	√
`12`	Fan	√
`13`	Fan cage			√
`14`	RAID super capacitor module	√
`15`	Standard air baffle			√
`16`	Serial port module	√
`17`	Backplane, eight 2.5-inch hot-swap drives	√
`18`	Backplane, twelve 3.5-inch hot-swap drives	√
`19`	Backplane, eight 3.5-inch hot-swap drives	√
`20`	Right rack latch, with front I/O assembly	√
`21`	Left rack latch, with VGA connector	√
`22`	Right rack latch, without front I/O assembly			√
`23`	Left rack latch, without VGA connector			√
`24`	Chassis		√
`25`	Security bezel	√
`26`	Front I/O assembly, server models with eight 3.5-inch drive bays	√
`27`	Front I/O assembly, server models with eight or sixteen 2.5-inch drive bays	√
`28`	Filler, 3.5-inch drive			√
`29`	Storage drive, 3.5-inch, hot-swap	√
`30`	Filler, 2.5-inch drive			√
`31`	Storage drive, 2.5-inch, hot-swap	√
`32`	Large-size air baffle			√
`33`	Riser 2 bracket	√
`34`	Riser card	√
`35`	Riser 1 bracket	√
`36`	PCIe adapter	√
`37`	Rear hot-swap drive assembly	√
`38`	Power supply	√
`39`	CMOS battery (CR2032)			√
`40`	M.2 drive	√
`41`	M.2 retainer	√
`42`	M.2 backplane	√
`43`	480 GB M.2 drive air baffle	√

Give documentation feedback