Skip to main content

System board assembly replacement (trained technician only)

Follow instructions in this section to remove and install the system board assembly.

Important
  • This task must be operated by trained technicians that are certified by Lenovo Service. Do not attempt to remove or install the part without proper training and qualification.

  • If you need to replace a processor board and a firmware and RoT security module together, do the following:

    • Check the current PSB fuse policy before replacement. See Service process before replacement at Service process for updating PSB fuse state (Lenovo service technicians only).

    • Ensure that the processor fuse status is expected without unexpected XCC event logs after replacement. See Service process after replacing a processor board and a firmware and RoT security module together at Service process for updating PSB fuse state (Lenovo service technicians only). The fuse status must be the same as the original fuse status of the server.

The following illustration shows the layout of the system board assembly that contains the firmware and RoT security module, system I/O board, and processor board.

Figure 1. System-board-assembly layout
System-board-assembly layout

1 System I/O board2 Firmware and RoT security module3 Processor board