Skip to main content

Remove an M.2 drive

Follow instructions in this section to remove an M.2 drive. The procedure must be executed by a trained technician.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
  • If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand via the operating system.
  • Before you remove or make changes to drives, drive controllers (including controllers that are integrated on the system board), drive backplanes or drive cables, back up all important data that is stored on drives.
  • Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration information.

Procedure

  1. Make preparation for this task.
    1. Remove the 2U compute shuttle. See Remove the 2U compute shuttle.
    2. Remove the processor air baffle. See Remove the processor air baffle.
  2. Locate the M.2 drive slots on the system board.
    Figure 1. M.2 drive slots
    M.2 drive slots
    1 Slot 12 Slot 2
  3. Remove the upper M.2 drive.
    1. Slide the upper retainer backward as illustrated to disengage the M.2 drive.
    2. The M.2 drive will slightly lift away from the system board.
    3. Hold the edge of the M.2 drive to pull it out of the M.2 drive slot at an angle of approximately 15 degrees.
      Figure 2. Removing upper M.2 drive
      Removing upper M.2 drive
  4. Remove the lower M.2 drive.
    1. Pull the lower retainer as illustrated to disengage the M.2 drive.
    2. The M.2 drive will slightly lift away from the system board.
    3. Hold the edge of the M.2 drive to pull it out of the M.2 drive slot at an angle of approximately 15 degrees.
      Figure 3. Removing lower M.2 drive
      Removing lower M.2 drive

After you finish

  • Install a replacement unit. See Install an M.2 drive.

  • If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.