Skip to main content

Remove an M.2 drive

Follow instructions in this section to remove an M.2 drive. The procedure must be executed by a trained technician.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
  • If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand via the operating system.
  • Before you remove or make changes to drives, drive controllers (including controllers that are integrated on the system board assembly), drive backplanes or drive cables, back up all important data that is stored on drives.
  • Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration information.

Procedure

  1. Remove the 2U compute shuttle. See Remove the 2U compute shuttle.
  2. Remove the M.2 drive.
    1. Press the retainer from the both sides.
    2. Slide the retainer away from the M.2 drive
    3. Rotate the rear end of the M.2 drive to an angle.
    4. Remove the M.2 drive from the M.2 backplane.
      Figure 1. M.2 drive removal
      M.2 drive removal

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.