Skip to main content

Install the intrusion switch

Follow instructions in this section to install the intrusion switch.

About this task

To avoid potential danger, read and follow the following safety statements.
  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read the Installation guidelines to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Push the intrusion switch in the slot until it clicks into place.
    Figure 1. Installing the intrusion switch
    Installing the intrusion switch
  2. Connect the cable to the corresponding connector on the system board. See System-board components and Intrusion switch and RAID flash power module.

After this task is completed

Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube