Skip to main content

Install a simple-swap drive (bay 0-1)

Follow instructions in this section to install a simple-swap drive to bay 0 or bay 1.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
About this task
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

  • Make sure the type of drives to be installed is supported. Following are the types supported:
    • 3.5-inch simple-swap hard-disk drive or solid-state drive in drive bay 0, drive bay 2 and drive bay 3.
    • 2.5-inch simple-swap solid-state drive in drive bay 1.
    For a complete list of supported optional devices for the server, see Lenovo ServerProven website.
  • If there are more than one drives to be installed, determine installation order based on the following rules:

    • Start with solid-state drives, and proceed with hard-disk drives.

    • When installing one 3.5-inch solid-state drive and one 3.5-inch hard-disk drive, install the solid-state drive in bay 0 and the hard-disk drive in bay 2.

    • Start with the drive with the lowest capacity.

    • Start with bay 0, proceed to bay 1, and bay 2, and then bay 3.

    Note
    Drives of different types and different capacities are allowed to be installed in one server, but not in the same RAID array. The drives in a single RAID array must be the same type and the same capacity.

Procedure

  1. Install a 3.5-inch or 2.5-inch drive to the retainer.
    Note
    To prevent from damaging the drive with static discharge, do not touch the circuit board on the bottom of the drive.
    Figure 1. Circuit board on the drive
    Circuit board on the drive
    1. Slightly tear both sides of the retainer apart.
    2. Align the four holes on the drive with the corresponding pins on the retainer; then, fit the drive into the retainer.
      Note
      The drive connectors should face the retainer handles.
      Figure 2. Installing a 3.5-inch drive into the retainer
      Installing a 3.5-inch drive into the retainer
      Figure 3. Installing a 2.5-inch drive into the retainer
      Installing a 2.5-inch drive into the retainer
  2. Face the retainer handles upward and push the drive assembly into the drive bay. Press the drive assembly firmly to ensure it is seated correctly.
    Figure 4. Installing the 3.5-inch drive assembly into drive bay 0
    Install 3.5-inch drive assembly into drive bay 0
    Figure 5. Installing the 2.5-inch drive assembly into drive bay 1
    Install 2.5-inch drive assembly into drive bay 1
  3. Connect the signal and power cables to the drive assembly. See Internal cable routing.
After you finish

  1. Complete the parts replacement. See Complete the parts replacement.

  2. Check the drive activity LED on the front of the server to verify if the drives are operating correctly. See Front view .

  3. Use the Lenovo XClarity Provisioning Manager Lite to configure the RAID if necessary. For more information, see RAID Setup.