Skip to main content

Install the M.2 boot adapter

Follow instructions in this section to install the M.2 boot adapter.

About this task

To avoid potential danger, read and follow the following safety statements.
  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Procedure

  1. If a bracket is installed in the chassis, open the PCIe adapter retainer bracket and remove the bracket from the chassis. Keep the bracket for future use.
  2. Remove the screw on the back of the PCIe adapter.
    Figure 1. Removing the screw on the back of the PCIe adapter
    Removing the screw on the back of the PCIe adapter
  3. Secure the M.2 boot adapter to the PCIe adapter.
    1. Align the M.2 boot adapter with the T-head pin on the PCIe adapter as illustrated, and slide it into place.
    2. Tighten the captive screw on the M.2 boot adapter.
    3. Tighten the screw from Step 1 to secure the M.2 boot adapter to the PCIe adapter.
    Figure 2. Securing the M.2 boot adapter to the PCIe adapter
    Securing the M.2 boot adapter to the PCIe adapter
  4. Connect the power and signal cables to the M.2 boot adapter.
    Figure 3. Installing the M.2 power and signal cables
    Installing the M.2 power and signal cables

After you finish

  1. Install the M.2 drives to the M.2 boot adapter. See Install an M.2 drive.

  2. Install the PCIe adapter that secures the M.2 boot adapter. See Install a PCIe adapter.
    Note
    The M.2 boot adapter can only be installed in PCIe slot 3.

  3. Connect the power cable and the signal cable to the system board. See Internal cable routing.

  4. Install the server cover. See Install the server cover.

  5. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube