Internal cable routing
Some of the components in the server come with internal cables meant for specific connectors.
Cable routing guidelines
Before connecting the cables, read the following guidelines carefully:
Turn off the server before you connect or disconnect any internal cables.
Refer to the documentation that comes with any external devices for additional cabling instructions.
Make use of the identifiers printed on the cables to locate the proper connectors.
Ensure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.
Note
Disengage all latches, release tabs, or locks on cable connectors when you disconnect cables from the system board. Failing to release them before removing the cables will damage the cable sockets on the system board, which are fragile. Any damage to the cable sockets might require replacing the system board.
Figure 1. Pressing the release tab to disengage the connector
Figure 2. Squeezing the release tabs at both sides to disengage the connector
Give documentation feedback