Skip to main content

Remove an M.2 drive

Follow instructions in this section to remove an M.2 drive.

About this task

  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

Procedure

  1. Make preparation for this task.
    1. Remove the server cover. See Remove the server cover.
      Attention
      The heat sinks and processor could be very hot. To avoid burning yourself, wait for a few minutes after turning off the server before you remove the server cover.
    2. Disconnect the M.2 boot adapter cables from the system board.
    3. Remove the PCIe adapter that secures the M.2 boot adapter. See Remove a PCIe adapter.
  2. Remove the M.2 drive.
    1. Press both sides of the retainers.
    2. Slide the retainer backwards to loosen the M.2 drive from the M.2 boot adapter.
    3. Pivot the M.2 drive away from the M.2 boot adapter.
    4. Pull the M.2 drive away from the connector at an angle.
    Figure 1. Removing an M.2 drive
    Removing an M.2 drive

After you finish

  1. Install a replacement unit. See Install an M.2 drive.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube